PROJECTS > Any project in metal or alloy

2x72 Belt Grinder

(1/2) > >>

jocat54:
I have been getting this together-finally got to the point of assembly to test it out. It didn't blow up or smoke ;D so maybe it will work out okay
Used a 2hp treadmill motor and made the controller using an scr and diode bridge (about $18) ;D
Still need to make a tool rest and electric box for the on/off switch and scr controller and find the room for it :)
A special thanks to Jake for the motor and metal

Jake Parker:
It looks good!
Did the gas strut work out OK?

Terrywerm:
That looks real good, jocat!  Are you going to add a table on the front side?

jocat54:

--- Quote from: Jake Parker on December 28, 2018, 10:08:48 PM ---It looks good!
Did the gas strut work out OK?

--- End quote ---

Jake I didn't use the strut--thought it was too heavy of spring.
Just used a spring in the square tubing.

jocat54:

--- Quote from: Terrywerm on December 29, 2018, 10:01:47 AM ---That looks real good, jocat!  Are you going to add a table on the front side?

--- End quote ---

Thanks Terry. Yes I have it made (not painted yet) Will post some pictures with it done.

Navigation

[0] Message Index

[#] Next page

Go to full version