Author Topic: The "not" rod  (Read 704 times)

Jake Parker

Re: The "not" rod
« Reply #15 on: August 27, 2018, 03:16:59 PM »
Thats the grass my kids havent stompped down. Its also at the edge of the sprinkler they play in, so it gets watered often.

PJB

Re: The "not" rod
« Reply #16 on: September 23, 2018, 12:12:05 PM »
Looks like it has a Reeves Drive too which is very cool
So tell me - What's your fair share of everything I've worked for??? Nothing?  Correct answer!
I cordially invite you to join me in starving and beating our govt back to it's honeymoon physique.

Jake Parker

Re: The "not" rod
« Reply #17 on: October 15, 2018, 12:32:33 PM »
I got a few minutes of shop time over the weekend, and got the drive hub for the "not rod" done.
I used the old sprocket to make the mounting flang for the new sprocket.

Jake Parker

Re: The "not" rod
« Reply #18 on: October 15, 2018, 12:37:58 PM »
I bored the center hole out to its finall size, and turned a shaft between centers to mount it on the lathe.
I got the hub to its size for the new sprocket to fit snug then skimmed the flange to make it all true, and square.
« Last Edit: October 15, 2018, 07:35:04 PM by Jake Parker »

Jake Parker

Re: The "not" rod
« Reply #19 on: October 15, 2018, 12:39:49 PM »
I then turned the teeth off by cutting into the root.
When I got close to through, I was able to break them off in a complete ring with a plastic hammer.

Jake Parker

Re: The "not" rod
« Reply #20 on: October 19, 2018, 11:16:37 PM »
Holes, 8 of them. Plus 8 5/16" bolts, and 8 nylock nuts.
Im glad I bought a deviding head! I bolted it to the Frances Reed drill press and cominced to poking holes.