Author Topic: 0-12" Shares mic set  (Read 1241 times)

Jake Parker

0-12" Shares mic set
« on: September 08, 2018, 08:39:11 PM »
The local craigslist ad had a 0-12" mic. set for $200.
I called and offered $180, and it was accepted.
We met at an agreed location, and now they have a new home.
The sellar was moving to a new state, and job and wouldent need anything over 1".


Carpenter84

Re: 0-12" Shares mic set
« Reply #1 on: September 08, 2018, 08:48:30 PM »
Wow!
Shawn

First 9x42 column mill, 9x42 Induma Knee mill,
Enterprise 10x28 lathe,
Ko Lee 6x12 surface grinder,
D. McKenzie 15" metal shaper,
Airco dip/stick 160 welder,

4GSR

Re: 0-12" Shares mic set
« Reply #2 on: September 08, 2018, 08:50:27 PM »
Nice find, with standards.
Ken

f350ca

Re: 0-12" Shares mic set
« Reply #3 on: September 08, 2018, 09:13:11 PM »
Nice score. I only have mics to 6 inch and a times could use larger. For now I have to rely on a 24 inch dial calliper.

Greg

Bill Gruby

Re: 0-12" Shares mic set
« Reply #4 on: September 16, 2018, 08:06:48 PM »
 Did you back up to the seller so he could not see that big grin on your face Jake? Very nice score.

 "Billy G"
Don't sweat getting old, you'll still do dumb crap, just slower.

An Optimist will tell you the glass is half full, the pessimist half empty, the engineer will say the glass is twice as big as it needs to be.

Carpenter84

Re: 0-12" Shares mic set
« Reply #5 on: September 16, 2018, 08:15:10 PM »
Did you back up to the seller so he could not see that big grin on your face Jake? Very nice score.

 "Billy G"

Lol...
Shawn

First 9x42 column mill, 9x42 Induma Knee mill,
Enterprise 10x28 lathe,
Ko Lee 6x12 surface grinder,
D. McKenzie 15" metal shaper,
Airco dip/stick 160 welder,

grumpygator

Re: 0-12" Shares mic set
« Reply #6 on: September 16, 2018, 09:11:22 PM »
Nice score Jake.
   **G**