Author Topic: Stuart No4 Casting Set  (Read 1935 times)

f350ca

Re: Stuart No4 Casting Set
« Reply #45 on: December 27, 2018, 07:58:09 PM »
Not the best knurl I've ever made, but defiantly the smallest, thats a 6-32 thread sticking out.
This is the lock to hold the handle in forward or reverse.

f350ca

Re: Stuart No4 Casting Set
« Reply #46 on: January 03, 2019, 07:37:16 PM »
Keep forgetting to take the camera out to the shop, so not keeping up with photo's
Need two drain cocks for the cylinder, finished one and struggled to carry it into the house for a photo.
The body is 5/16 with a 1/4 hex and 10 - 32 thread. The pocket for the stem is tapered using a reamer for tapered dowel pins.

f350ca

Re: Stuart No4 Casting Set
« Reply #47 on: February 02, 2019, 05:31:04 PM »
Made a valve for the engine.       

woodchucker

Re: Stuart No4 Casting Set
« Reply #48 on: February 02, 2019, 05:35:59 PM »
Made a valve for the engine.     


nice, any pics of the parts b4 assembly?
Jeff
Clausing 8520   SB Model 9a - power hacksaw, Milwaukee band saw in a table.  Delta Rockwell Surface Grinder (not online yet .. being rebuilt where am I going to stick this)
For pics: https://imgur.com/user/woodchucker/posts

f350ca

Re: Stuart No4 Casting Set
« Reply #49 on: February 02, 2019, 05:39:32 PM »
Sorry Jeff, no the camera on my phone quit and I keep forgetting to bring this pone out to the shop.
The body is two parts silver soldered together. The piping is 1/4 SS tubing, the stem is 6-32 thread

Greg